CallSign.co
FCC Question ID  
T1E01
When is an amateur station permitted to transmit without a control operator?
When using automatic control, such as in the case of a repeater
When the station licensee is away and another licensed amateur is using the station
When the transmitting station is an auxiliary station
Never
T1D08
In which of the following circumstances may the control operator of an amateur station receive compensation for operating that station?
When the communication is related to the sale of amateur equipment by the control operator's employer
When the communication is incidental to classroom instruction at an educational institution
When the communication is made to obtain emergency information for a local broadcast station
All of these choices are correct
T1F03
When is an amateur station required to transmit its assigned call sign?
At the beginning of each contact, and every 10 minutes thereafter
At least once during each transmission
At least every 15 minutes during and at the end of a communication
At least every 10 minutes during and at the end of a communication
T1A02
Which agency regulates and enforces the rules for the Amateur Radio Service in the United States?
FEMA
Homeland Security
The FCC
All of these choices are correct
T1C08
What is the normal term for an FCC-issued primary station/operator amateur radio license grant?
Five years
Life
Ten years
Twenty years
T1B08
Which of the following is a result of the fact that the Amateur Radio Service is secondary in all or portions of some amateur bands (such as portions of the 70 cm band)?
U.S. amateurs may find non-amateur stations in those portions, and must avoid interfering with them
U.S. amateurs must give foreign amateur stations priority in those portions
International communications are not permitted in those portions
Digital transmissions are not permitted in those portions
T2A01
Which of the following is a common repeater frequency offset in the 2 meter band?
Plus or minus 5 MHz
Plus or minus 600 kHz
Plus or minus 500 kHz
Plus or minus 1 MHz
T2B07
How can you join a digital repeater’s “talk group”?
Register your radio with the local FCC office
Join the repeater owner’s club
Program your radio with the group’s ID or code
Sign your call after the courtesy tone
T2C10
What information is contained in the preamble of a formal traffic message?
The email address of the originating station
The address of the intended recipient
The telephone number of the addressee
The information needed to track the message
T3A10
What may occur if data signals arrive via multiple paths?
Transmission rates can be increased by a factor equal to the number of separate paths observed
Transmission rates must be decreased by a factor equal to the number of separate paths observed
No significant changes will occur if the signals are transmitted using FM
Error rates are likely to increase
T3B06
What is the formula for converting frequency to approximate wavelength in meters?
Wavelength in meters equals frequency in hertz multiplied by 300
Wavelength in meters equals frequency in hertz divided by 300
Wavelength in meters equals frequency in megahertz divided by 300
Wavelength in meters equals 300 divided by frequency in megahertz
T3C09
What is generally the best time for long-distance 10 meter band propagation via the F layer?
From dawn to shortly after sunset during periods of high sunspot activity
From shortly after sunset to dawn during periods of high sunspot activity
From dawn to shortly after sunset during periods of low sunspot activity
From shortly after sunset to dawn during periods of low sunspot activity
T4A10
What is the source of a high-pitched whine that varies with engine speed in a mobile transceiver’s receive audio?
The ignition system
The alternator
The electric fuel pump
Anti-lock braking system controllers
T4B02
Which of the following can be used to enter the operating frequency on a modern transceiver?
The keypad or VFO knob
The CTCSS or DTMF encoder
The Automatic Frequency Control
All of these choices are correct
T5A11
What is the unit of electromotive force?
The volt
The watt
The ampere
The ohm
T5B13
If a frequency display shows a reading of 2425 MHz, what frequency is that in GHz?
0.002425 GHz
24.25 GHz
2.425 GHz
2425 GHz
T5C10
How much power is being used in a circuit when the applied voltage is 12 volts DC and the current is 2.5 amperes?
4.8 watts
30 watts
14.5 watts
0.208 watts
T5D16
What is the voltage across each of two components in parallel with a voltage source?
It is determined by the type and value of the components
Half the source voltage
Twice the source voltage
The same voltage as the source
T6A04
What electrical component stores energy in an electric field?
Resistor
Capacitor
Inductor
Diode
T6B08
What does the abbreviation FET stand for?
Field Effect Transistor
Fast Electron Transistor
Free Electron Transmitter
Frequency Emission Transmitter
T6C10
What is component 3 in figure T3?
Connector
Meter
Variable capacitor
Variable inductor
T6D01
Which of the following devices or circuits changes an alternating current into a varying direct current signal?
Transformer
Rectifier
Amplifier
Reflector
T7A02
What is a transceiver?
A type of antenna switch
A unit combining the functions of a transmitter and a receiver
A component in a repeater that filters out unwanted interference
A type of antenna matching network
T7B07
Which of the following can reduce overload to a VHF transceiver from a nearby FM broadcast station?
RF preamplifier
Double-shielded coaxial cable
Using headphones instead of the speaker
Band-reject filter
T7C04
What reading on an SWR meter indicates a perfect impedance match between the antenna and the feed line?
2 to 1
1 to 3
1 to 1
10 to 1
T7D02
What is the correct way to connect a voltmeter to a circuit?
In series with the circuit
In parallel with the circuit
In quadrature with the circuit
In phase with the circuit
T8A11
What is the approximate maximum bandwidth required to transmit a CW signal?
2.4 kHz
150 Hz
1000 Hz
15 kHz
T8B10
What do the initials LEO tell you about an amateur satellite?
The satellite battery is in Low Energy Operation mode
The satellite is performing a Lunar Ejection Orbit maneuver
The satellite is in a Low Earth Orbit
The satellite uses Light Emitting Optics
T8C08
What is the Internet Radio Linking Project (IRLP)?
A technique to connect amateur radio systems, such as repeaters, via the internet using Voice Over Internet Protocol (VoIP)
A system for providing access to websites via amateur radio
A system for informing amateurs in real time of the frequency of active DX stations
A technique for measuring signal strength of an amateur transmitter via the internet
T8D11
What is an ARQ transmission system?
A special transmission format limited to video signals
A system used to encrypt command signals to an amateur radio satellite
A digital scheme whereby the receiving station detects errors and sends a request to the sending station to retransmit the information
A method of compressing the data in a message so more information can be sent in a shorter time
T9A04
What is a disadvantage of the “rubber duck” antenna supplied with most handheld radio transceivers when compared to a full-sized quarter-wave antenna?
It does not transmit or receive as effectively
It transmits only circularly polarized signals
If the rubber end cap is lost, it will unravel very easily
All of these choices are correct
T9B08
Why should coax connectors exposed to the weather be sealed against water intrusion?
To prevent an increase in feed line loss
To prevent interference to telephones
To keep the jacket from becoming loose
All of these choices are correct
T0A06
What is a good way to guard against electrical shock at your station?
Use three-wire cords and plugs for all AC powered equipment
Connect all AC powered station equipment to a common safety ground
Use a circuit protected by a ground-fault interrupter
All of these choices are correct
T0B05
What is the purpose of a gin pole?
To temporarily replace guy wires
To be used in place of a safety harness
To lift tower sections or antennas
To provide a temporary ground
T0C03
What is the maximum power level that an amateur radio station may use at VHF frequencies before an RF exposure evaluation is required?
1500 watts PEP transmitter output
1 watt forward power
50 watts PEP at the antenna
50 watts PEP reflected power